I discovered the issue

The other day as I was going about our business like doing the dishes and taking care of some other chores around the beach house, I suddenly felt all frightening cold; I recognize I had not noticed how it was getting progressively colder in the beach house because I was in the middle of chores, however when I did notice I went over to check on the thermostat, then according to the thermostat it was 64 degrees inside however the natural gas furnace was set for 78 degrees. I tried flipping the main switch off and on again, however nothing happened. It was at this time that I began to realize that something was wrong with the gas furnace. I went into the basement to inspect the inside of the gas furnace, however nothing looked out of locale so I decided to reset the igniter to see if that could help. I turned off the circuit breaker and switched the igniter off for 90 minutes as it says in the instruction manual. After numerous hours I switched the power on again and turned the gas furnace on at the thermostat; Still nothing, and either the igniter was thoroughly shot or something else was wrong. As I had not an inkling of how to proceed from that point on I called an Heating, Ventilation as well as A/C professional to take care of it, but the Heating, Ventilation as well as A/C professional seemed more than a little impressed by the things I did and told me I should look into a career as a Heating, Ventilation as well as A/C professional… He then went through a bunch of tests and figured out that something was melted on the circuit board. That is something I would have never even thought about doing.